Fix Your Stuff Community Store

Razer DeathAdder Chroma Outer Casing Replacement

Prerequisite Only
This guide is only intended to be used as a prerequisite for other guides. It's incomplete by itself.

Introduction

This is a prerequisite for all DeathAdder Chroma replacement guides.

What you need

  1. Razer DeathAdder Chroma Outer Casing Replacement, Outer Casing: step 1, image 1 of 1

    • Opening the mouse casing will void any warranty that exists for the mouse.

    • Turn the mouse over so the bottom is facing up.

    Edit

  2. Razer DeathAdder Chroma Outer Casing Replacement: step 2, image 1 of 2 Razer DeathAdder Chroma Outer Casing Replacement: step 2, image 2 of 2

    • Use the blunt end of the spudger to pry the adhesive rubber pads from the top left and right edges.

    Edit

  3. Razer DeathAdder Chroma Outer Casing Replacement: step 3, image 1 of 2 Razer DeathAdder Chroma Outer Casing Replacement: step 3, image 2 of 2

    • Use a Phillips #0 screwdriver to remove two 6.7 mm screws.

    Edit

  5. Razer DeathAdder Chroma Outer Casing Replacement: step 4, image 1 of 1

    • Use your fingers to identify the location of the screw under the bottom label.

    Edit

  6. Razer DeathAdder Chroma Outer Casing Replacement: step 5, image 1 of 1

    • Use a Phillips #0 screwdriver to remove one 6.7 mm screw.

    • Clear the label away from around the screw for easier removal.

    Edit

  7. Razer DeathAdder Chroma Outer Casing Replacement: step 6, image 1 of 3 Razer DeathAdder Chroma Outer Casing Replacement: step 6, image 2 of 3 Razer DeathAdder Chroma Outer Casing Replacement: step 6, image 3 of 3

    • Turn the mouse over so the bottom is facing down.

    • Separate the top casing from the bottom base by pulling the top casing upwards.

    • Separating the casing too quickly could damage the ribbon connector between the motherboard and the LED lights.

    Edit

  8. Razer DeathAdder Chroma Outer Casing Replacement: step 7, image 1 of 2 Razer DeathAdder Chroma Outer Casing Replacement: step 7, image 2 of 2

    • Disconnect the ribbon connector between the motherboard and the LED lights by pulling upward.

    • Pulling too hard could damage the wire connections.

    Edit
Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

with 1 other contributor

Corrie Tung

Member since: 03/24/17

702 Reputation

2 Guides authored

Badges: 12

+9 more badges

Team

Baylor, Team S5-G2, Williams Spring 2017 Member of Baylor, Team S5-G2, Williams Spring 2017

BU-WILLIAMS-S17S5G2

3 Members

6 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 0

All Time: 78