Introduction

Use for a diagnosed wiring problem.

  1. Remove the backplate.
    • Remove the backplate.

    • Using a Torx T20 screwdriver, remove the four screws attaching the back plate.

    Add Comment

  2. Remove the drill handle.
    • Remove the drill handle.

    • Using the Phillips #2 screwdriver, remove the five screws attaching the drill handle to the body.

    Add Comment

  3. GIVE TOOLS. FIX FOREVER.

    GIVE TOOLS.

    FIX FOREVER.

    Spread the Fixmas cheer.

    GIVE TOOLS. FIX FOREVER.

    Spread the Fixmas cheer.

    • Remove the gear casing from the body.

    • Using the Philips #2 screwdriver, remove the four screws attaching the gear casing to the body.

    Add Comment

    • Use a multimeter set above 18V DC to check electrical connections where wires meet drill, switch, or battery terminal.

    Add Comment

    • Look for corrosion or burnt wires.

    • If there are any bad connections or if there is visible damage, replace damaged wire and solder.

    Add Comment

    • After soldering sand off jaged solder then wrap with electrical tape

    Tin the broken wires with Rosen core solder and do not overuse the solder. Heat one side pretinned wire and place the other pretinned wire on that till the solder melts together. Remove iron and cool and you should have a quality repair. Don’t forget to add heat shrink before doing the connection.

    brennanmichael - Reply

Conclusion

To reassemble your device, follow these instructions in reverse order.

One other person completed this guide.

Evan Long

Member since: 04/15/2010

232 Reputation

4 Guides authored

Team

Cal Poly, Team 15-48, Garner Spring 2010 Member of Cal Poly, Team 15-48, Garner Spring 2010

CPSU-GARNER-S10S15G48

6 Members

5 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 1

Past 7 Days: 4

Past 30 Days: 32

All Time: 4,080