Fix Your Stuff Community Store

RIDGID Belt Sander R2740 Brush Assembly Replacement

Introduction

If your RIDGID Belt Sander is low on power or does not turn on at all, you may need to replace the motor brushes. This guide will show you how to replace the motor brushes on your belt sander. For this task you will just need a standard screw driver.

What you need

  1. RIDGID Belt Sander R2740 Brush Assembly Replacement, Brush Assembly: step 1, image 1 of 1

    • Move to the front side of the sander.

    • Remove the brush cap with a standard screw driver.

    Edit

  3. RIDGID Belt Sander R2740 Brush Assembly Replacement: step 2, image 1 of 1

    • With the brush cap off, the brush should spring out .

    • With the brush hanging out, gently pull it out.

    Edit

  4. RIDGID Belt Sander R2740 Brush Assembly Replacement: step 3, image 1 of 1

    • For the other brush turn to the back side of the belt sander and repeat steps one and two.

    Edit
Conclusion

To reassemble your device, follow these instructions in reverse order.

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 5

Past 30 Days: 14

All Time: 828