Image 1/1:
  • Start by turning the tablet over with the screen down. The carefully use a plastic opening tool to pry the cover off. Start from the corner opposite the hibernate button.

Add Comment

Image 1/2: Image 2/2:
  • Pick up the magnets from the bottom edge of the tablet next to the keyboard connection and put them in a place that they will not get lost. Then carefully remove all 4 strips of electrical tape.

Add Comment

Image 1/2: Image 2/2:
  • Using a small plastic opening tool; genteelly pull the connection off of the motherboard.

Add Comment

Image 1/3: Then place cover off to the side. Image 2/3: Then place cover off to the side. Image 3/3: Then place cover off to the side.
  • Using a PH00 Philips screwdriver bit remove 5 screws from the cover on top of the keyboard solid state board.

  • Then place cover off to the side.

Add Comment

Image 1/3: Then using a plastic opening tool slowly and carefully wedge the tool between the cable ribbon and the black connector portion. Then carefully rock the tool up and down to lift the connector hinge. Image 2/3: The board can now be removed. Image 3/3: The board can now be removed.
  • Using a PH000 Philips screw driver bit remove the two screws on securing the board to the case.

  • Then using a plastic opening tool slowly and carefully wedge the tool between the cable ribbon and the black connector portion. Then carefully rock the tool up and down to lift the connector hinge.

  • The board can now be removed.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 5

All Time: 51