Introduction
The Protocol Dronium 3x rotor guards are responsible for protecting the drone's props. Additional rotor guards are included with the Dronium 3x.
What you need
-
-
Set the drone upright.
-
Using the Phillips #0 screwdriver, remove the 6mm screw from each corner of the drone.
-
Place the rotor guards aside and replace with guards of choice.
-
-
Almost done!
To reassemble your device, follow these instructions in reverse order.
Conclusion
To reassemble your device, follow these instructions in reverse order.
Team
Washington State, Team S29-G7, Hope Fall 2018 Member of Washington State, Team S29-G7, Hope Fall 2018
WSU-HOPE-F18S29G7
3 Members
4 Guides authored
