Introduction

This is the camera replacement guide. If you find the camera of the ProScan PLT 7050 is broken, follow these steps to replace the camera.

Make sure device is unplugged and turned off while working on the device.
  • Make sure device is unplugged and turned off while working on the device.

  • Remove 2 Phillips head, 4.3 mm screws from the bottom side of the tablet with a PH00 screwdriver.

Add Comment

Use the plastic opening tools to pry the back of the tablet open.
  • Use the plastic opening tools to pry the back of the tablet open.

  • You may need to slide the tool along the sides of the device to get it to open. You might hear some popping noises, it is okay.

  • May be helpful if you start by the microSD slot.

Add Comment

Deck the Halls
With tools and Fix Kits
Remove the black tape carefully.
  • Remove the black tape carefully.

Add Comment

Use the plastic opening tool to open the ZIF connector tab to release the camera's ribbon cable.
  • Use the plastic opening tool to open the ZIF connector tab to release the camera's ribbon cable.

Add Comment

Remove the camera's ribbon cable.
  • Remove the camera's ribbon cable.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 0

All Time: 114