Introduction

Two RAM slots allow up to 1 GB of PC133 RAM.

Image 1/1: Turn the keyboard locking screw so that it is parallel to the space bar.
  • Remove the battery.

  • Turn the keyboard locking screw so that it is parallel to the space bar.

  • Pull the keyboard release tabs toward you and lift up on the keyboard until it pops free.

Add Comment

Image 1/1: Disconnect the keyboard connector from the logic board.
  • Rest the keyboard face down on the trackpad area.

  • Disconnect the keyboard connector from the logic board.

Add Comment

Image 1/1:
  • Your laptop should look approximately like this.

Add Comment

Image 1/1: Pull the RAM chip out.
  • Release the tabs on each side of the RAM chip at the same time. These tabs lock the chip in place and releasing them will cause the chip to ÒpopÓ up.

  • Pull the RAM chip out.

  • Repeat this process if a second RAM chip is installed.

Don't forget to spread the brackets on the sides apart to release the chips.

Calion - Reply

Conclusion

To reassemble your device, follow these instructions in reverse order.

4 other people completed this guide.

Attached Documents

iRobot

Member since: 09/24/2009

1 Reputation

715 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 1

Past 7 Days: 2

Past 30 Days: 7

All Time: 6,514