Introduction

Two RAM slots allow up to 1 GB of PC100 or PC133 RAM.

Remove the battery.
  • Remove the battery.

  • Turn the keyboard locking screw so that it is parallel to the space bar.

  • Pull the keyboard release tabs toward you and lift up on the keyboard until it pops free.

Add Comment

Rest the keyboard face down on the trackpad area.
  • Rest the keyboard face down on the trackpad area.

  • Disconnect the keyboard connector from the logic board.

Add Comment

Your laptop should look approximately like this.
  • Your laptop should look approximately like this.

Add Comment

Release the tabs on each side of the RAM chip at the same time. These tabs lock the chip in place and releasing them will cause the chip to "pop" up.
  • Release the tabs on each side of the RAM chip at the same time. These tabs lock the chip in place and releasing them will cause the chip to "pop" up.

  • Pull the RAM chip out.

  • Repeat this process if a second RAM chip is installed.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

13 other people completed this guide.

Attached Documents

iRobot

Member since: 09/24/2009

1 Reputation

726 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 1

Past 7 Days: 2

Past 30 Days: 17

All Time: 8,487