Introduction

Removing the heat shield enables access to the RAM and the processor below.

Turn the keyboard locking screw so that it is parallel to the space bar.
  • Turn the keyboard locking screw so that it is parallel to the space bar.

  • Pull the keyboard release tabs toward you and lift up on the keyboard until it pops free.

  • Lift the keyboard out by pulling it up and away from you. Rest the keyboard, face down, on top of the track pad.

Add Comment

Pull the keyboard ribbon straight up from the logic board. Place the keyboard aside.
  • Pull the keyboard ribbon straight up from the logic board. Place the keyboard aside.

  • The connector may be tight. Gently rock the connector from side to side while pulling directly upward to free it. You can use this technique on many of the cards and cables you'll be disconnecting.

  • Make sure you have removed the laptop battery and CD/DVD modules from the expansion bays before proceeding.

Add Comment

Your laptop should look approximately like this.
  • Your laptop should look approximately like this.

Add Comment

Remove the two silver Phillips #1 screws that attach the heat shield to the internal metal framework.
  • Remove the two silver Phillips #1 screws that attach the heat shield to the internal metal framework.

  • Lift the heat shield up and pull it toward you.

On my M7572, these are T9s not Philips.

Rufleyboy - Reply

Your laptop should look approximately like this.
  • Your laptop should look approximately like this.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

2 other people completed this guide.

Attached Documents

iRobot

Member since: 09/24/2009

1 Reputation

726 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 3

All Time: 2,774