Introduction

After frequent use of the controller, the buttons may get worn out and possibly get stuck depending on how long the controller has been used. Because of this frequent repetitive use, the buttons may need to be replaced.

What you need

Step 1 Rear Case

PowerA Spectra Controller Buttons Replacement, Rear Case: step 1, image 1 of 1

Flip the controller over so the backplate is facing up.

Edit

Step 2

Use a Phillips #2 screwdriver to remove the eight 7.8 mm screws that secure the rear case.

Edit

Step 3

Hold the front case in one hand and pull the rear case off.

Edit

Step 4 Buttons

PowerA Spectra Controller Buttons Replacement, Buttons: step 4, image 1 of 1

Use a Phillips screwdriver to remove the two 7.8 mm screws securing the motherboard to the chassis.

Edit

Step 5

Pull the motherboard away from the controller to access the buttons.
The motherboard is not fully removable because it is attached to the D-Pad. Be careful not to rip the motherboard from the D-Pad.

Edit

Step 6

Pull the old buttons out of the shell of the controller using the angled tweezers.

Edit

Conclusion

To reassemble your device, follow the above steps in reverse order.
Repair didn’t go as planned? Try some basic troubleshooting or ask our Answers community for help.