Introduction

Often times power cords can get damaged through long-term use, or mishandling of the device. Whatever the case, the power cord of the Porter-Cable PC60TAG can be replaced in a few easy steps.

Parts

No parts required.

Using the Phillips #2 screwdriver, remove the 3/4" Phillips head screw on the back cover.
  • Using the Phillips #2 screwdriver, remove the 3/4" Phillips head screw on the back cover.

  • Unplug the grinder before disassembling.

Add Comment

Holding the front of the device, carefully slide the back cover over the cord.
  • Holding the front of the device, carefully slide the back cover over the cord.

Add Comment

Black Friday
Broken doesn't stand a chance.
Using the Phillips #2 screwdriver, remove the two 1/2" Phillips head screws securing the cord grip.
  • Using the Phillips #2 screwdriver, remove the two 1/2" Phillips head screws securing the cord grip.

Add Comment

Using the Phillips #2 screwdriver, loosen, but do not remove, the two terminal screws securing the black and white wires from the power cord.
  • Using the Phillips #2 screwdriver, loosen, but do not remove, the two terminal screws securing the black and white wires from the power cord.

Add Comment

Careful remove each wire from the power cord from underneath the terminals.
  • Careful remove each wire from the power cord from underneath the terminals.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Mackenzie Fairbanks

Member since: 03/24/2016

501 Reputation

5 Guides authored

Team

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 1

All Time: 99