Introduction

Replacing a broken or scratched lens on a Polaroid Sun 600 LMS.

Image 1/2: Pull film door open. Image 2/2: Pull film door open.
  • Move film door slide on the left side of camera forward.

  • Pull film door open.

Add Comment

Image 1/2: If your camera is old or dirty, it may take more force to open the flash assembly. Image 2/2: If your camera is old or dirty, it may take more force to open the flash assembly.
  • Open the flash assembly by holding the sides of the top piece of the camera and pushing up gently until it snaps into place.

  • If your camera is old or dirty, it may take more force to open the flash assembly.

Add Comment

Image 1/2: Be careful not to do this too hard because you may pull out the connecting wires. Image 2/2: Be careful not to do this too hard because you may pull out the connecting wires.
  • Use a spudger on each side to separate the flash segment from the main body.

  • Be careful not to do this too hard because you may pull out the connecting wires.

Add Comment

Image 1/2: Image 2/2:
  • Use several plastic opening tools around the edges of the camera's body to separate it from the plastic frame.

Add Comment

Image 1/2: Pull the sections apart. Image 2/2: Pull the sections apart.
  • Place left hand on the gray section and right hand on the black section.

  • Pull the sections apart.

Add Comment

Image 1/2: Replace with a new lens. Image 2/2: Replace with a new lens.
  • Carefully remove the damaged lens from the interior of the camera.

  • Replace with a new lens.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

One other person completed this guide.

Ian Hosek

Member since: 01/20/2010

333 Reputation

1 Guide authored

Team

Cal Poly, Team 3-18, Maness Winter 2010 Member of Cal Poly, Team 3-18, Maness Winter 2010

CPSU-MANESS-W10S3G18

4 Members

4 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 1

Past 7 Days: 9

Past 30 Days: 71

All Time: 6,818