Introduction
If you need to replace the film door latch, use this guide to access the inside of the camera. You may need to replace the latch if your camera will not close.
What you need
-
-
Unscrew the four 5mm screws on the base of the camera using a Phillips #0 screwdriver.
-
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
4 other people completed this guide.
Team
University of Alabama, Team S1-G1, Bedsole Fall 2018 Member of University of Alabama, Team S1-G1, Bedsole Fall 2018
UA-BEDSOLE-F18S1G1
4 Members
5 Guides authored
2 Comments
This doesn’t actually say anything about replacing the latch…
But where do you buy a replacement latch?
