Introduction

The spread roll spring is a vital part of the polaroid that ensures that your developing photo will exit the camera once your photo is taken.

Parts

No parts required.

Push the lever on the bottom of the camera towards the left. Open the rear door of the camera.
  • Push the lever on the bottom of the camera towards the left.

  • Open the rear door of the camera.

Add Comment

Unlatch the red clip on the side. Lift the rollers up. Position the camera with the back cover closest to you.
  • Unlatch the red clip on the side.

  • Lift the rollers up.

  • Position the camera with the back cover closest to you.

Add Comment

Remove the rear roll by using the plastic opening tool to take it off the metal frame. Then remove the front roll by pushing away from you with the plastic opening tool. Then remove the front roll by pushing away from you with the plastic opening tool.
  • Remove the rear roll by using the plastic opening tool to take it off the metal frame.

  • Then remove the front roll by pushing away from you with the plastic opening tool.

Add Comment

Unscrew the three 2.5 mm screws (attached to the metal plate) with a 3.0 flathead screwdriver. Then take off the metal plate.
  • Unscrew the three 2.5 mm screws (attached to the metal plate) with a 3.0 flathead screwdriver. Then take off the metal plate.

Add Comment

Pull the support rod out.
  • Pull the support rod out.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Katie Miller

Member since: 04/14/2015

626 Reputation

5 Guides authored

Team

Cal Poly, Team 4-3, Maness Spring 2015 Member of Cal Poly, Team 4-3, Maness Spring 2015

CPSU-MANESS-S15S4G3

4 Members

5 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 1

Past 30 Days: 6

All Time: 261