Introduction

This guide shows how to replace the speakers of the Poin2 Chromebook 11.

Power down the Poin2 Chromebook 11 and disconnect the power adapter.
  • Power down the Poin2 Chromebook 11 and disconnect the power adapter.

  • Close the Chromebook and position it with the base facing up.

  • Use a #0 Phillips screwdriver to unscrew the ten 7mm screws that hold the base to the rest of the frame

    • Poin2 Chromebook 11 does not have screws under its rubber feet at the base.

Add Comment

Insert a 1cm-wide plastic opening tool between the base and top frame.
  • Insert a 1cm-wide plastic opening tool between the base and top frame.

    • Applying pressure up and down with the tool may be necessary. When you hear a "click," this indicates the separation of the frame.

  • Pry (up and down) around the entire border of the Chromebook to separate.

  • Use your hands to gently lift the base away from the frame.

Add Comment

  • Disconnect the white 8-wire battery connector from the motherboard using a spudger to push the two L-shaped clips out of the port.

    • The connector is a tight fit and requires careful pressure for release.

Add Comment

  • Remove the six 4mm screws using a Phillips #0 screwdriver.

Add Comment

  • Lift the battery from the frame.

Add Comment

  • Unplug the black speaker cable from the lower, left side of the motherboard.

Add Comment

  • Use the opening tool to pry the two speakers away from the frame.

  • An adhesive strip attaches each speaker to the frame. The speakers should pull away with moderate force.

Add Comment

  • Detach the speaker cord from the hooks holding it to the frame and lift the speakers away.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 0

All Time: 104