Pododent Motor NSK Japan Bearing Replacement

Step 1 ball-bearing

• The picture shows the items. In the handpiece are the motor housing with the top right anchor. Underneath, on the right, is the clamping body for the tools and to the left thereof the receptacle of the clamping body. The engine is to take after replacement of the ball bearings about 350mA at 24 volts.
Translate
Add a comment
Add a comment
Add Comment
1024
Cancel Post comment
Step 2



• To prevent water from entering the drive, I cut silicone gaskets out of an old cable and put them on the tubes. Now, no water can penetrate the camps.
Translate
Add a comment
Add a comment
Add Comment
1024
Cancel Post comment

Special thanks to these translators:

de en

100%

irlanda

irlanda is helping us fix the world! Want to contribute?
Start translating ›

Author

with 1 other contributor

Michael

Member since: 01/08/16

37 Reputation

1 Guide authored

Badges: 3

• 
• 
• 

Embed this guide

Choose a size and copy the code below to embed this guide as a small widget on your site / forum.

Preview