1. Remove the parallel port cover on the back of the PlayStation
    • Remove the parallel port cover on the back of the PlayStation

    Add Comment

  2. Flip over the PlayStation and remove the six screws from the bottom.
    • Flip over the PlayStation and remove the six screws from the bottom.

    Add Comment

    • Turn the PlayStation upright. Remove the cover by lifting it up.

    Add Comment

    • Carefully disconnect the gold-colored ribbon cable from it's connector.

    • To avoid damaging the cable, pull it by the white, reinforced tab.

    Add Comment

    • Disconnect the second cable by pulling up on the plastic connector at the end.

    Add Comment

    • Lift the optical drive off of the PlayStation.

    Add Comment

    • Remove the two screws and take off the bottom piece for your new Optical drive from the old one.

    Add Comment

    • Take the new lens either from a SCPH-7501 or SCPH-9001.

    • To avoid damaging the cable, Gently lift on this gold-colored cable that has a pot screw on it and lift it, but not too much.

    Add Comment

    • Take the bottom piece and screw the two screws on the new Optical Drive.

    Add Comment

    • Plug the cables back in. Your work should look like this. Put it back together, plug it in, turn it on and see if it works.

    Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Unchi

Member since: 10/27/2013

367 Reputation

2 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 2

Past 30 Days: 7

All Time: 1,137