Introduction
This will guide you through the replacement of your controller port.
What you need
-
-
-
Remove the two screws securing the controller port to the case.
Ask FixBot
-
-
-
-
Gently disconnect the ribbon cable from the logic board. This is done by pulling on the blue area of the cable near the connector.
-
-
Conclusion
To reassemble your device, follow these instructions in reverse order.
Team
Cal Poly, Team 5-2, Regan Fall 2009 Member of Cal Poly, Team 5-2, Regan Fall 2009
CPSU-REGAN-F09S5G2
5 Members
60 Guides authored
