Skip to main content

Photive Hydra Face Plate and Back Plate Replacement

Prerequisite Only
This guide is only intended to be used as a prerequisite for other guides. It's incomplete by itself.

What you need

  1. Photive Hydra Face Plate and Back Plate Replacement, Face Plate and Back Plate: step 1, image 1 of 1
    • Unscrew all twelve Hex Head 1.5 (Length-3/8", Head- 1/8") screws using a 1.5mm hex screwdriver.

  2. Photive Hydra Face Plate and Back Plate Replacement: step 2, image 1 of 2 Photive Hydra Face Plate and Back Plate Replacement: step 2, image 2 of 2
    • Use a plastic opening tool to pry off the face plate.

  3. Photive Hydra Face Plate and Back Plate Replacement: step 3, image 1 of 1
    • Remove the rubber casing by using your fingers to pull off. Be sure not tear or rip rubber casing.

  4. Photive Hydra Face Plate and Back Plate Replacement: step 4, image 1 of 1
    • Flip the device upside down and remove all eight Phillips (Length-3/8", Head-1/8") Screws using a standard #1 Phillips screwdriver.

  5. Photive Hydra Face Plate and Back Plate Replacement: step 5, image 1 of 2 Photive Hydra Face Plate and Back Plate Replacement: step 5, image 2 of 2
    • Use plastic opening tool to pry off back plate.

    • Move the plastic opening tool along the the device to further pry open the device.

    • Be careful when taking this plate off. You may accidentally damage the water proof seal.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Andrew Chase

Member since: 02/09/16

352 Reputation

3 Guides authored

Team

USF Tampa, Team 11-3, Cheng Spring 2016 Member of USF Tampa, Team 11-3, Cheng Spring 2016

USFT-CHENG-S16S11G3

5 Members

6 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 0

All Time: 88