Introduction
This bed side light is a bit tricky to open.
Purpose of this was to install an antenna jack (BNC) to attach a telescopic antenna or roof aerial.
What you need
-
-
Flipping the light upside down, pry upward the small plastic strip with hooks that has to be removed.
-
-
-
-
Now the screws holding the front screen shield need to be removed and the shield can be pulled away to the front.
-
CAREFUL NOT TO DAMAGE THE INTERNAL SCREEN
-
Unscrew the four screws holding the inner screen assembly in place.
-
-
-
The inner screen assembly can be pulled out slightly to reveal tabs on each side that hold the assembly in.
-
Pry the back tabs inwards to release.
-