Tools

Parts

No parts required.

  1. Turn over the Delphi MyFi XM2GO Device on its back to start the cover-removal process.
    • Turn over the Delphi MyFi XM2GO Device on its back to start the cover-removal process.

    Add Comment

  2. Locate the large button on the top back of the device.
    • Locate the large button on the top back of the device.

    • Press this button at the top while making a firm grip on the battery cover.

    • As the button is pressed, move the cover towards the bottom of the device.

    • The battery removal tab may pop up during the cover removal process.

    Add Comment

    • Holding the device, grab the tab with thumb and index figure.

    • Pull down on the tab to move the battery block a few millimeters towards the bottom of the device to unlock the latch at the top.

    • After the latch at the top is disengaged, pivot the battery away from the back and the battery will be free.

    Add Comment

    • After removing the battery cover and battery, locate the reset (indicated by arrow).

    Add Comment

    • Unbend the paper clip, making it straight. CAUTION: The ends may be sharp.

    • Carefully insert one end of the paper clip into the hole to reset the device.

    Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

One other person completed this guide.

Aubrey

Member since: 03/09/2012

54 Reputation

3 Guides authored

Team

Clemson, Team 1-2, Benson Spring 2012 Member of Clemson, Team 1-2, Benson Spring 2012

CLEM-BENSON-S12S1G2

3 Members

9 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 5

Past 7 Days: 8

Past 30 Days: 23

All Time: 5,116