Introduction

Button replacement may be necessary if the shutter button sticks or no longer activates shutter due to wear.

Parts

No parts required.

The top cover is one piece encasing the top of the device except the shutter release button and flash.
  • The top cover is one piece encasing the top of the device except the shutter release button and flash.

Add Comment

With the camera lens face down, locate the screw under the overhanging piece of the top casing on the right side of the back panel. Using the J0 screwdriver, remove the 6.3 mm screw.
  • With the camera lens face down, locate the screw under the overhanging piece of the top casing on the right side of the back panel.

  • Using the J0 screwdriver, remove the 6.3 mm screw.

Add Comment

Locate the next screw by holding the camera upside down with the battery compartment empty and face up. Remove the 6.3 mm screw using a J0 screwdriver.
  • Locate the next screw by holding the camera upside down with the battery compartment empty and face up.

  • Remove the 6.3 mm screw using a J0 screwdriver.

Add Comment

The next screw is found in the overhanging piece just above the lens. With the top of the camera facing down, remove the 3.4 mm screw with a J0 screwdriver.
  • The next screw is found in the overhanging piece just above the lens.

  • With the top of the camera facing down, remove the 3.4 mm screw with a J0 screwdriver.

Add Comment

Gently pull off the top cover with your hands by pulling on the tab on the left of the camera. Gently pull off the top cover with your hands by pulling on the tab on the left of the camera.
  • Gently pull off the top cover with your hands by pulling on the tab on the left of the camera.

Add Comment

Gently remove the beige rubber tabs from under the casing by pulling each down using tweezers. Gently remove the beige rubber tabs from under the casing by pulling each down using tweezers.
  • Gently remove the beige rubber tabs from under the casing by pulling each down using tweezers.

Add Comment

Remove the 3 buttons by pushing them from under the casing out through the top.
  • Remove the 3 buttons by pushing them from under the casing out through the top.

  • Each button is slotted differently, so pay attention to the orientation of each piece.

Add Comment

The buttons are now free to be replaced or cleaned.
  • The buttons are now free to be replaced or cleaned.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Jonathan Diaz

Member since: 04/20/2015

213 Reputation

2 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 1

Past 30 Days: 1

All Time: 186