Introduction

Replacement guide for the circuit board of the Pebble Time.

Lay the watch flat on your workstation.
  • Lay the watch flat on your workstation.

Use the metal spudger to carefully pull apart the screen cover from the case. Replace the metal spudger with a plastic opening tool to hold the cover open.
  • Use the metal spudger to carefully pull apart the screen cover from the case.

  • Replace the metal spudger with a plastic opening tool to hold the cover open.

Use the metal spudger tool to carefully loosen the rest of the cover.
  • Use the metal spudger tool to carefully loosen the rest of the cover.

Carefully, pull apart the cover with the plastic opening tool.
  • Carefully, pull apart the cover with the plastic opening tool.

New Battery = Faster iPhone
Fix Kits starting at $16.99
Insert metal spudger into the side of the screen shown in the picture.
  • Insert metal spudger into the side of the screen shown in the picture.

Use the metal spudger to pry the screen up.
  • Use the metal spudger to pry the screen up.

Once screen is lifted, insert plastic opening tool between the screen connector and circuit board. Disconnect the screen from the circuit board. Disconnect the screen from the circuit board.
  • Once screen is lifted, insert plastic opening tool between the screen connector and circuit board.

  • Disconnect the screen from the circuit board.

Keep the watch flat on your workstation.
  • Keep the watch flat on your workstation.

Locate the three screws on the circuit board.
  • Locate the three screws on the circuit board.

  • Remove using the J000 Philips head screwdriver.

Carefully disconnect the connector wire on the bottom left edge of the circuit board using a plastic opener tool. Move apart the connector to expose the fourth screw. Move apart the connector to expose the fourth screw.
  • Carefully disconnect the connector wire on the bottom left edge of the circuit board using a plastic opener tool.

  • Move apart the connector to expose the fourth screw.

Remove the final screw from the circuit board with a J000 Philips head screwdriver.
  • Remove the final screw from the circuit board with a J000 Philips head screwdriver.

Turn the watch to the side and use the plastic opening tool to lift up the circuit board. Remove the circuit board from the case.
  • Turn the watch to the side and use the plastic opening tool to lift up the circuit board.

  • Remove the circuit board from the case.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Nicolas Hempe

Member since: 02/15/2017

550 Reputation

5 Guides authored

Team

USF Tampa, Team 1-3, Sullivan Spring 2017 Member of USF Tampa, Team 1-3, Sullivan Spring 2017

USFT-SULLIVAN-S17S1G3

4 Members

6 Guides authored

Add Comment

View Statistics:

Past 24 Hours: 1

Past 7 Days: 3

Past 30 Days: 18

All Time: 125