Introduction

This guide will walk you through steps to replace your joystick.

Total of 6 Screws are located in the back of the controller.
  • Total of 6 Screws are located in the back of the controller.

    • Four 0.9mm T6 screws

    • Two 0.1mm T6 screws

  • Flip the Flypad over.

  • Remove the six screws using a T6 screwdriver.

  • Use a Magnetic Mat to prevent loss of screws. Set aside.

Add Comment

Flip the Flypad over again and separate the front and back. Be sure to remove the foam adhesive that connects the front plate to the motherboard.
  • Flip the Flypad over again and separate the front and back. Be sure to remove the foam adhesive that connects the front plate to the motherboard.

  • Be aware that the Buttons (L1,R1) may fall out. Remember to put them back in place during reassembly.

  • Use Ph0 tool to remove the screws holding the motherboard in place.

  • Gently remove the motherboard from the front plate.

The FLYPAD’s that come with the FPV kit do not have the weights and the rumble motor. The sticks are also not removable.

Heath - Reply

Pop the joysticks out by pulling gently. Pop the joysticks out by pulling gently.
  • Pop the joysticks out by pulling gently.

Please add the removal of the motherboard screws. Also I have 3 of these controllers. The oldest has PHILLIPS head screws. The newest has the T6 screws. Just FYI.

Heath - Reply

Unscrew and replace joystick caps for a more comfortable grip.
  • Unscrew and replace joystick caps for a more comfortable grip.

The Flypad that comes with the FPV kit does not have removable joystick caps.

Heath - Reply

Conclusion

To reassemble your device, follow these instructions in reverse order.

HUY NGUYEN

Member since: 04/10/2017

352 Reputation

3 Guides authored

Team

UW Tacoma, Team S3-G5, Liner Spring 2017 Member of UW Tacoma, Team S3-G5, Liner Spring 2017

UWT-LINER-S17S3G5

5 Members

3 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 4

Past 30 Days: 13

All Time: 184