Introduction

Camera lens' play a huge role in making cameras effective. Replacing a lens is easy as 1-2-3 and only takes 10-13 minutes.

Parts

No parts required.

Image 1/3: Image 2/3: Image 3/3:
  • Take a Phillips Head screwdriver and remove the 2mm screws on the left and right side of the camera.

Add Comment

Image 1/1: Then remove the 3 Phillips 2mm screws located in the middle of the aluminum plating.
  • Remove the 3 Phillips 4mm screws located on the aluminum plating inside the camera.

  • Then remove the 3 Phillips 2mm screws located in the middle of the aluminum plating.

Add Comment

Image 1/2: Once the camera is in the right position, lift up the aluminum plating. Image 2/2: Once the camera is in the right position, lift up the aluminum plating.
  • Lay the camera on the front side where the aluminum panel is facing up.

  • Once the camera is in the right position, lift up the aluminum plating.

Add Comment

Image 1/2: Unplug both copper wiring plugs from the motherboard. Image 2/2: Unplug both copper wiring plugs from the motherboard.
  • Stand the camera up in the upright position.

  • Unplug both copper wiring plugs from the motherboard.

Add Comment

Image 1/3: The camera lens should slide out. (Pry it out with a spudger or a plastic opening tool if needed) Image 2/3: The camera lens should slide out. (Pry it out with a spudger or a plastic opening tool if needed) Image 3/3: The camera lens should slide out. (Pry it out with a spudger or a plastic opening tool if needed)
  • Lift your camera into the upright position

  • The camera lens should slide out. (Pry it out with a spudger or a plastic opening tool if needed)

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

One other person completed this guide.

Elijah Painter

Member since: 03/03/2015

138 Reputation

1 Guide authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 2

Past 7 Days: 5

Past 30 Days: 16

All Time: 693