Introduction

Step by step guide to replacing your damaged LCD Display

Tools

No tools required.

Parts

Remove the battery and memory card from the unit Remove 6 (0.3mm) screws from the sides of the unit Remove 5 (0.3mm) screws from the bottom of the unit
  • Remove the battery and memory card from the unit

  • Remove 6 (0.3mm) screws from the sides of the unit

  • Remove 5 (0.3mm) screws from the bottom of the unit

Add Comment

Mac RAM Kits
Speed up your Mac. Max out its memory.
Mac RAM Kits
Get more memory out of your Mac.
Lift up slightly the rear cover. Do not remove rear cover yet. It is still attached to the Main PCB.
  • Lift up slightly the rear cover.

  • Do not remove rear cover yet. It is still attached to the Main PCB.

  • Flip up the cable clamps using a spudger or other device. Careful not to break the clamps. Release flex cables and remove back cover.

Add Comment

Release the 3 metal clips from the rear cover and remove the LCD Release the 3 metal clips from the rear cover and remove the LCD Release the 3 metal clips from the rear cover and remove the LCD
  • Release the 3 metal clips from the rear cover and remove the LCD

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Sales Cameraparts4you

Member since: 07/01/2016

2,097 Reputation

18 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 1

Past 30 Days: 7

All Time: 124