Introduction

This guide will show the user how to disassemble the camera to reach the Flash Top Assembly. Once the Flash Top Assembly is reached, the user can replace it.

Parts

No parts required.

Image 1/1: Slide the latch to the open position.
  • Locate the memory card and battery card latch on the bottom of the camera.

  • Slide the latch to the open position.

Add Comment

Image 1/1:
  • Open the battery latch, and slide the battery release lever to the right.

Add Comment

Image 1/1:
  • Remove the battery from the camera.

Add Comment

Image 1/1: Use this screwdriver for all screws in the device.
  • Using a size #00 Phillips screwdriver, remove the three 4.58 mm screws on the bottom of the camera.

  • Use this screwdriver for all screws in the device.

Add Comment

Image 1/1:
  • Remove the 3.15 mm screw on the left side of the camera.

Add Comment

Image 1/2: Image 2/2:
  • Remove the left side casing.

Add Comment

Image 1/1:
  • Remove the two 3.15 mm screws on the right side of the camera.

Add Comment

Image 1/1:
  • Remove the bottom right panel.

Add Comment

Image 1/2: Start at the bottom and carefully pry towards the top to get this piece free. Image 2/2: Start at the bottom and carefully pry towards the top to get this piece free.
  • Gently remove the back casing.

  • Start at the bottom and carefully pry towards the top to get this piece free.

Add Comment

Image 1/2: Image 2/2:
  • Carefully pry the Flash Top Assembly away from the top.

Add Comment

Image 1/2: Image 2/2:
  • Replace the Flash Top Assembly with a new one.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Caleb Fink

Member since: 10/11/2010

186 Reputation

2 Guides authored

Team

Cal Poly, Team 9-22, Regan Fall 2010 Member of Cal Poly, Team 9-22, Regan Fall 2010

CPSU-REGAN-F10S9G22

4 Members

8 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 3

All Time: 3,466