Introduction

Steps for removing the back half of the case and replacing it with a new one.

Parts

No parts required.

Image 1/1: Use your finger to slide battery hatch towards the arrow sign.
  • Slide the lock into the unlock position.In this case you would need to slide the lock to the right.

  • Use your finger to slide battery hatch towards the arrow sign.

  • Both battery and memory card should now be visible.

Add Comment

Image 1/1: The camera used to create these repair guides did not have a battery and memory card.
  • Open battery hatch and the black cover to expose the battery compartment.

  • The camera used to create these repair guides did not have a battery and memory card.

  • Pull the battery out and replace with a new one.

  • When putting the battery back in, make sure it is in the same orientation as before.

  • Close the battery compartment and make sure the lock is in the locked position.

Add Comment

Image 1/1: The camera used to create these repair guides and did not have the other screw./'''Make this a note and a different color from the step above.'''
  • Remove the two 2.8 mm Phillips screws as shown in picture. There are two screws that need to be removed./Remove the two 2.8 mm Phillip screws shown in the picture. Two screws need to be removed.

  • The camera used to create these repair guides and did not have the other screw./Make this a note and a different color from the step above.

Add Comment

Image 1/1:
  • Remove the three 2.8 mm Phillips screws on the bottom of the camera as shown in picture./Mention in this step that a screwdriver is supposed to be used here. Also, possibly make a close up of this picture for a better view.

Add Comment

Image 1/1:
  • Remove the two 2.8 mm Phillips screws on the side of the camera as shown in picture. /state that a screwdriver is needed in the step.

Add Comment

Image 1/2: Image 2/2:
  • Use a Spudger tool to pry open case from all sides./No edits necessary

Add Comment

Image 1/2: Use your fingers to carefully pry off the back casing from the camera assembly/. '''No edits necessary.''' Image 2/2: Use your fingers to carefully pry off the back casing from the camera assembly/. '''No edits necessary.'''
  • Beware of yellow film strip when opening./Caution: Beware of the yellow film strip when opening the casing of the camera, make this caution notice a different color.

  • Use your fingers to carefully pry off the back casing from the camera assembly/. No edits necessary.

Add Comment

Image 1/1: Use Spudger tool to open the film strip locking mechanism and remove strip./'''No edits necessary.'''
  • Lay the camera on its front side./combine this sentence to the step below.

  • Use Spudger tool to open the film strip locking mechanism and remove strip./No edits necessary.

  • Hold down on the camera's metal casing with one hand. Using your other hand, completely lift the back case off the rest of the camera, making sure the film strip separates./Make a picture for this step.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

One other person completed this guide.

Alex Penman

Member since: 01/28/2011

480 Reputation

4 Guides authored

Team

Cal Poly, Team 7-35, Regan Winter 2011 Member of Cal Poly, Team 7-35, Regan Winter 2011

CPSU-REGAN-W11S7G35

4 Members

5 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 0

All Time: 673