Repairing Palm Treo 650 Camera

Step 1 Battery and Stylus

• Position the phone so the screen faces down.
• Remove the stylus found on the back of the phone.
Step 2

• Hold the button in the middle of the phone's back to remove the battery cover.
• Slide the cover down to remove it, and set the cover aside.
Step 3
• Lift the edge of the battery, separating contact points, and pull out as pictured.
Step 4 Case
• Remove the round, rubber cover to expose a screw that will be removed in the next step.
Step 5
• Remove the six 6.9 mm screws as pictured with a T5 Torx screwdriver.
• Remove the single 9.8 mm screw next to the antenna on the back plate, using a Phillips #00 screwdriver.
Step 6
• Pull the antenna outward to remove the antenna from the body of the phone.
Step 7
• Pry the back cover off using an iFixit opening tool.
• Several small clips on the inside attach to the back cover.
Step 8 Camera
• Remove the two 3.75 mm screws.
• Pull off the logic board.
Step 9
• Pull the rubber ring off of the camera.
Step 10
• Pry off the metal camera case.
• Lift up the camera, but do not remove. The connector must be detatched first.
Step 11
• Pry off the camera connector plug.
• Remove the camera.

Author

with 5 other contributors

cgood

Member since: 10/28/09

122 Reputation

7 Guides authored

Badges: 10

• 
• 
• 

+7 more badges

Team

Cal Poly, Team 19-3, Maness Fall 2009 Member of Cal Poly, Team 19-3, Maness Fall 2009

CPSU-MANESS-F09S19G3

4 Members

18 Guides authored

Embed this guide

Choose a size and copy the code below to embed this guide as a small widget on your site / forum.

Preview