Introduction

These steps will allow you to replace the screen with a new one.

On the back of the device, locate the 3 rubber plugs, and use a plastic spudger to remove them.
  • On the back of the device, locate the 3 rubber plugs, and use a plastic spudger to remove them.

Add Comment

Use the T6 Torx Screwdriver to remove all 4 screws. You have to first remove the Stylus to  access the 4th screw.
  • Use the T6 Torx Screwdriver to remove all 4 screws.

  • You have to first remove the Stylus to access the 4th screw.

Add Comment

Using a plastic opening tool, carefully separate the front and back cases. Note: The antenna will detach from the phone.
  • Using a plastic opening tool, carefully separate the front and back cases.

  • Note: The antenna will detach from the phone.

Add Comment

Using a T6 Torx Screwdriver, remove the two screws. The motherboard will now be loose from the front case.
  • Using a T6 Torx Screwdriver, remove the two screws.

  • The motherboard will now be loose from the front case.

Add Comment

The screen is connected to the phone with an orange data cable.
  • The screen is connected to the phone with an orange data cable.

  • Slide the spudger as close to the connection as possible.

  • Gently pull the spudger up and the cable should come out of the socket.

Add Comment

Once the cable is unplugged, you can remove the screen from the body. Once the cable is unplugged, you can remove the screen from the body.
  • Once the cable is unplugged, you can remove the screen from the body.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Clement Poisson

Member since: 01/26/2010

24 Reputation

7 Guides authored

Team

Cal Poly, Team 13-23, Maness Winter 2010 Member of Cal Poly, Team 13-23, Maness Winter 2010

CPSU-MANESS-W10S13G23

4 Members

8 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 0

All Time: 2,032