Skip to main content

Shop the Holiday Gift Guide
Free Shipping on Domestic Orders $75+

Palm Pre Speaker Replacement

Views: 499

View statistics:

Past 24 Hours:
1
Past 7 Days:
2
Past 30 Days:
8
All Time:
499
Comments: 0

No one has left comments on this guide. Will you be first?

Go to guide comments
Completed: 0

No one has marked this guide "completed." Will you be the first?

Favorites: 0

No one has favorited (and subscribed to) this guide. Will you be the first?

Time Required: No estimate
Difficulty: Very easy
Archived Guide

This guide is retained solely for historical purposes. Use the updated version of the guide to perform your repair.

Confusing Text

Some of this guide's text is confusing, duplicated, or off-topic. Clarify it by editing!

Community-Contributed Guide

An awesome member of our community made this guide. It was not created by iFixit staff.

Mismatched Prerequisites

This guide does not have a proper prerequisite guide. Help match it to its ideal partner by finding it or writing one!

Palm Pre Speaker Replacement

Introduction

Go to step 1 ↓

This guide will show you how to readjust or replace the speaker if it is performing poorly.

What you need

Tools

  • Spudger
    4.9
    1. Palm Pre Speaker Replacement, Antenna: step 1, image 1 of 2 Palm Pre Speaker Replacement, Antenna: step 1, image 2 of 2
      • First the back panel must be removed to reveal the battery.

      • Remove the battery pack.

      Ask FixBot

      Add Comment

    2. Palm Pre Speaker Replacement: step 2, image 1 of 2 Palm Pre Speaker Replacement: step 2, image 2 of 2
      • Remove the six T5 screws necessary to separate the backplate from the phone.

      • There is one screw in the upper right that is concealed by a small sticker labeled "Palm."

      • Additionally, there are interlocking tabs securing the back plate around the edges.

      • Use the opening tool to carefully go around the phone releasing these tabs.

      Ask FixBot

      Add Comment

    3. Palm Pre Speaker Replacement: step 3, image 1 of 2 Palm Pre Speaker Replacement: step 3, image 2 of 2
      • Lift the metal flap marked in red to reveal the antenna connectors.

      • Carefully pry these the antennas from their connections, this can be done quite easily.

      • Take note of which colored wire is attached to each connection. The white wire corresponds to GPS, while the black wire corresponds to DIV, or diversity antenna.

      Ask FixBot

      Add Comment

    1. Palm Pre Speaker Replacement, Speaker: step 4, image 1 of 3 Palm Pre Speaker Replacement, Speaker: step 4, image 2 of 3 Palm Pre Speaker Replacement, Speaker: step 4, image 3 of 3
      • With the backplate removed, the speaker is visible.

      • Pry out speaker with spudger.

      • It is magnetically attached so there should be a little bit of resistance; however, there are no wires to disconnect.

      • Take note of the orientation of the speaker for re-installation.

      Ask FixBot

      Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

with

iDeleted

Member since: 07/07/10

2,101 Reputation

39 Guides authored

0 Guide Comments

Add Comment

View Statistics:

Past 24 Hours: 1

Past 7 Days: 2

Past 30 Days: 8

All Time: 499