Introduction

This guide show you how to remove and replace the Palm Centro's speakers

Parts

No parts required.

  1. Press and slide open the battery cover.
    • Press and slide open the battery cover.

    Add Comment

  2. Caution: Turn cell phone off before removing battery!
    • Caution: Turn cell phone off before removing battery!

    • Press battery to the right.

    • Then lift up battery pack to remove.

    Add Comment

    • Phone with battery removed

    Add Comment

    • Remove the touchpad pen from the top left corner on the back to reveal the last of 6 screws to be removed.

    Add Comment

      • Lift the rubber cap at the top right to reveal the sixth screw.

      • Caution: There is a small Palm sticker under the rubber cap. Tampering with or removing this sticker will void your warranty!

      • Remove the six screws using the T5 Torx screwdriver.

    Add Comment

    • Remove the SIM card so housing can be separated.

    Add Comment

    • Use a plastic pry tool to separate the bottom of the case to remove the small plastic insert.

    Add Comment

    • Remove the small plastic insert at the bottom of the phone.

    Add Comment

    • Continue with plastic pry tool all the way around the phone to remove the back housing.

    Add Comment

    • Carefully peel back the tape holding the speaker (left) and keyboard (right) connection tabs in place.

    Add Comment

    • Using the plastic prying tool, lift the tabs and carefully pull the contact connections out on both sides.

      • Be very careful, these electronics are delicate!

    Add Comment

    • Separate the logic board from the case by lifting and pulling out the bottom.

    Add Comment

    • Pry the four plastic latches free that connect the antenna to the logic board.

      • Excessive force may damage your logic board!

    • Remove the antenna from the logic board.

    Add Comment

    • The internal speaker is attached to the antenna. To remove it, pry the speaker from the antenna using the tip of your screwdriver.

      • The speaker should be placed back into its spot in the correct position. Take notice of the gold connectors

    Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

One other person completed this guide.

Kevin

Member since: 04/12/2010

31 Reputation

1 Guide authored

Team

Cal Poly, Team 15-49, Garner Spring 2010 Member of Cal Poly, Team 15-49, Garner Spring 2010

CPSU-GARNER-S10S15G49

5 Members

12 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 2

All Time: 1,397