Introduction

Make you PSP 3000c like new again by replacing your beat up front case with a shiny new one!

  1. Press the button securing the battery door to the PSP 300xc, and lift the battery door off. Lift the battery out of the PSP.
    • Press the button securing the battery door to the PSP 300xc, and lift the battery door off.

    • Lift the battery out of the PSP.

  2. Use a spudger or your fingernail to remove the warranty sticker stuck to the inside of the battery tray
    • Use a spudger or your fingernail to remove the warranty sticker stuck to the inside of the battery tray

  3. Free shipping on all orders over $100 or containing a Pro Tech Toolkit!

    Browse Our Store
  4. Remove four Phillips screws from the back of the PSP. Remove four Phillips screws from the back of the PSP.
    • Remove four Phillips screws from the back of the PSP.

  5. Remove two Phillips screws from the top of the PSP.
    • Remove two Phillips screws from the top of the PSP.

  6. Remove a single screw from the bottom edge of the PSP.
    • Remove a single screw from the bottom edge of the PSP.

  7. Insert a spudger between the front case and PSP, and slide the spudger along the perimeter of the front case to remove it. Insert a spudger between the front case and PSP, and slide the spudger along the perimeter of the front case to remove it.
    • Insert a spudger between the front case and PSP, and slide the spudger along the perimeter of the front case to remove it.

Conclusion

To reassemble your device, follow these instructions in reverse order.

One other person completed this guide.

Matthew Newsom

Member since: 01/05/2010

32,764 Reputation

67 Guides authored

0 Comments

View Statistics:

Past 24 Hours: 1

Past 7 Days: 2

Past 30 Days: 6

All Time: 2,073