Fix Your Stuff Community Store

PDP Victrix Gambit Prime Wired Tournament Controller Outer Case Replacement

Introduction

To clean out dust and debris from the controller, the outer casing must be removed for effectiveness. This will allow you to access the inner layer of the device and thoroughly wipe down any gunk that is causing malfunction.

What you need

  1. PDP Victrix Gambit Prime Wired Tournament Controller Outer Case Replacement, Outer Casing: step 1, image 1 of 1

    • Insert an opening tool in the gap between the rear and front case.

    • Pry around the perimeter until the front case releases.

    • Remove the front case.

    Edit

  3. PDP Victrix Gambit Prime Wired Tournament Controller Outer Case Replacement: step 2, image 1 of 1

    • Remove all seven 9 mm Phillips #000 screws securing the midframe.

    • Remove the midframe.

    Edit

  4. PDP Victrix Gambit Prime Wired Tournament Controller Outer Case Replacement: step 3, image 1 of 2 PDP Victrix Gambit Prime Wired Tournament Controller Outer Case Replacement: step 3, image 2 of 2

    • Optional: With a pair of tweezers, carefully wipe down the device.

    • It is recommended to use electrical disinfectant wipes or a microfiber towel to clean any excess debris.

    Edit
Conclusion

After you have thoroughly cleaned the device, follow these steps in reverse order to reassemble the device.

0 Guide Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 1

Past 30 Days: 7

All Time: 147