Oster 16-Speed Blender Fan and Motor Replacement

Step 1 Fan and Motor



• Remove the Blender Container from the Blender Base.
Step 2



• Flip the blender so the bottom is facing you.
Step 3
• Unscrew the 16mm screws located on the plastic bottom from the blender base using a Phillips #2 screwdriver.
Step 4
• Remove the plastic bottom from the base of the blender.
Step 5
• Holding the center of the fan, grip the knob in the center of the top of the blender with a wrench and twist the wrench counterclockwise.
Step 6
• Carefully remove the motor and fan from the base of the blender.
Step 7
• Now, gently pull the white wire that is connected to the base and the motor.
• Be careful, as there is a spring behind the contact points, that might try to shoot out and hurt you.
Step 8
• Now, turn the motor over, and remove the black wire from the motor.
• Again, be warned as the is another spring that wants to shoot out and hurt you here as well.
Step 9
• Now de-solder the yellow wire from circuit board. De-solder the wire following these instructions.
• Be careful, as there is another, black wire, nearby that you do not want to de-solder.

Author

with 2 other contributors

Dana

Member since: 04/14/14

773 Reputation

5 Guides authored

Badges: 10

• 
• 
• 

+7 more badges

Team

Cal Poly, Team 12-37, Maness Spring 2014 Member of Cal Poly, Team 12-37, Maness Spring 2014

CPSU-MANESS-S14S12G37

4 Members

5 Guides authored

Embed this guide

Choose a size and copy the code below to embed this guide as a small widget on your site / forum.

Preview