Introduction

By following the steps below, you will be able to remove and replace the speakers of your Oregon Scientific Meep! 4.0.

Use a screwdriver to remove the four 7.0 mm Philips #00 screws from the back of the device.
  • Use a screwdriver to remove the four 7.0 mm Philips #00 screws from the back of the device.

Add Comment

Use a plastic opening tool to detach the clips on the inside of the device.
  • Use a plastic opening tool to detach the clips on the inside of the device.

Add Comment

Deck the Halls
With tools and Fix Kits
Remove the electric tape holding the wires of the speakers in place and gently pull the speakers out of their slots in the device. Remove the electric tape holding the wires of the speakers in place and gently pull the speakers out of their slots in the device.
  • Remove the electric tape holding the wires of the speakers in place and gently pull the speakers out of their slots in the device.

Add Comment

Use a soldering station to separate the wires from the speakers. Use a soldering station to separate the wires from the speakers.
  • Use a soldering station to separate the wires from the speakers.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Jess Forte

Member since: 09/25/2015

419 Reputation

4 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 2

All Time: 84