Introduction

By following the steps in this guide in order, you will be able to remove and replace the broken motherboard of your Oregon Scientific Meep! 4.0 tablet.

Use a screwdriver to remove the four 7.0 mm Philips #00 screws from the back of the device.
  • Use a screwdriver to remove the four 7.0 mm Philips #00 screws from the back of the device.

Add Comment

Use a plastic opening tool to detach the clips on the inside of the device.
  • Use a plastic opening tool to detach the clips on the inside of the device.

Add Comment

Use a soldering station to disconnect any wires attached to the motherboard. Use a soldering station to disconnect any wires attached to the motherboard.
  • Use a soldering station to disconnect any wires attached to the motherboard.

Add Comment

Use a screwdriver to unscrew the three 4.0 mm Philips #00 screws holding the motherboard in place.
  • Use a screwdriver to unscrew the three 4.0 mm Philips #00 screws holding the motherboard in place.

Add Comment

Use a plastic opening tool to release the ribbon cables surrounding the motherboard.
  • Use a plastic opening tool to release the ribbon cables surrounding the motherboard.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Lauren Milici

Member since: 09/21/2015

207 Reputation

2 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 5

All Time: 123