Introduction
- First of all, you need a heat gun, screwdriver, T-7000 or T-8000 glue and a thin pickuse pry bar or ruler or anything thin to pry the back cover of the phone.
- Use a heat gun for 30 seconds to heat the glue that attaches the back cover to the phone.
- Use a thin pickuse pry bar or ruler or anything thin to pry the back cover.
- Now, you can see all screws that need to be removed on the camera lens, then take a screwdriver to remove that 5 screws.
- Then remove the old camera lens and replace it with a new one.
- After that, reattach the screw to the camera lens.
- Finally, use T-7000 or T-8000 glue to attach it on the corners and edge around the back cover, then put the back cover back on the back of the phone and wait for it to dry for 1 hour.
Conclusion
To reassemble your device, follow these instructions in reverse order.
0 Guide Comments