Skip to main content

Introduction

Use this guide to open the back cover of the Samsung Galaxy Watch.

  1. Remove the four Tri-point #00 screws (4.2 mm length) on the backside of the watch.
    • Remove the four Tri-point #00 screws (4.2 mm length) on the backside of the watch.

  2. Use an opening tool to get between the back cover and the metal housing of the watch. Carefully pry the plastic back cover open.
    • Use an opening tool to get between the back cover and the metal housing of the watch.

    • Carefully pry the plastic back cover open.

    • Don't remove the back cover yet. There is a flex cable running to the core assembly inside.

  3. Lay down the watch and lift the back cover to access the sensor connector on the motherboard. Lay down the watch and lift the back cover to access the sensor connector on the motherboard.
    • Lay down the watch and lift the back cover to access the sensor connector on the motherboard.

  4. Use a spudger to disconnect the sensor flex cable from the motherboard. Use a spudger to disconnect the sensor flex cable from the motherboard.
    • Use a spudger to disconnect the sensor flex cable from the motherboard.

  5. Remove the back cover. When closing the watch make sure the rubber gasket is undamaged or replace it with a new one. When closing the watch make sure the rubber gasket is undamaged or replace it with a new one.
    • Remove the back cover.

    • When closing the watch make sure the rubber gasket is undamaged or replace it with a new one.

Conclusion

To reassemble your device, follow these instructions in reverse order.

5 other people completed this guide.

Tobias Isakeit

Member since: 03/31/2014

85,879 Reputation

162 Guides authored

Team

iFixit Member of iFixit

Community

137 Members

16,041 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 6

Past 7 Days: 27

Past 30 Days: 134

All Time: 4,064