One Education Infinity:One Hinge Contact Assembly Replacement
Taylor Bratsch and 2 other contributors
Last updated on Dec 2, 2016
Views: 768
View statistics:
- Past 24 Hours:
- 4
- Past 7 Days:
- 19
- Past 30 Days:
- 76
- All Time:
- 768
Comments: 1
1 guide comment.
Go to guide commentsCompleted: 0 1
No one has marked this guide "completed." Will you be the first?
1 person has marked this guide "completed." It's you — great job!
Favorites: 0 1
No one has favorited (and subscribed to) this guide. Will you be the first?
1 person has favorited (and subscribed to) this guide — and that's you!
Introduction
Go to step 1 ↓This guide can be used to remove the entire hinge or the hinge contact assembly. The hinge, along with its contact assembly, connects the keyboard base with the tablet. If the tablet fails to recognize the keyboard, replacing this contact assembly might solve the problem.
What you need
Tools
-
-
-
Use a spudger to pry the four rubber pads away from the bottom of the case.
-
Use a Phillips #00 screwdriver to unscrew the four 6.4 mm screws.
Ask FixBot
-
-
-
Insert a Jimmy or other prying tool into the seam on the edge of the casing.
-
Trace along the edges of the device until all clips are released.
-
Lift the back case away from the device.
-
-
-
Use a Phillips #00 screwdriver to unscrew the four 6.4mm screws on the hinge mounts.
-
-
-
Tool used on this step:Tweezers$4.99
-
Use tweezers to lift the fabric cover and hinge connector away from the daughterboard.
-
-
-
-
-
Slide a Jimmy or other prying tool along the seam of the hinge to pry the casing apart.
-
-
-
Use a Phillips #00 screwdriver to remove the two 4.3mm screws holding the circuit board in place.
-
To reassemble your device, follow these instructions in reverse order.
1 Guide Comment
Everything is very detailed and shown. Everything is also done in detail on this site ++https://oceanessay.com/buy-thesis-pape... , which helps students learn. There you will find a lot of educational materials.
