Introduction

Follow this guide to replace the daughterboard in the One Education Infinity:One laptop.

Use a spudger to pry the four rubber pads away from the bottom of the case. Use a Phillips #00 screwdriver to unscrew the four 6.4 mm screws.
  • Use a spudger to pry the four rubber pads away from the bottom of the case.

  • Use a Phillips #00 screwdriver to unscrew the four 6.4 mm screws.

Add Comment

Insert a Jimmy or other prying tool into the seam on the edge of the casing. Trace along the edges of the device until all clips are released.
  • Insert a Jimmy or other prying tool into the seam on the edge of the casing.

  • Trace along the edges of the device until all clips are released.

  • Lift the back case away from the device.

Add Comment

Use a Phillips #00 screwdriver to unscrew the four 6.4mm screws on the hinge mounts.
  • Use a Phillips #00 screwdriver to unscrew the four 6.4mm screws on the hinge mounts.

Add Comment

Black Friday
Broken doesn't stand a chance.
Use tweezers to lift the fabric cover and hinge connector away from the daughterboard. Always use ESD safe tools when working with delicate electrical components.
  • Use tweezers to lift the fabric cover and hinge connector away from the daughterboard.

  • Always use ESD safe tools when working with delicate electrical components.

Add Comment

Flip up the black retaining flap on the ZIF connector holding the large grey ribbon cable in place. Pull the ribbon cable straight out of the ZIF connector.
  • Flip up the black retaining flap on the ZIF connector holding the large grey ribbon cable in place.

  • Pull the ribbon cable straight out of the ZIF connector.

Add Comment

Use the flat end of a spudger to flip up the black tab on the smaller ZIF connector. Use tweezers to pull the ribbon cable straight out of the connector.
  • Use the flat end of a spudger to flip up the black tab on the smaller ZIF connector.

  • Use tweezers to pull the ribbon cable straight out of the connector.

Add Comment

Use a Phillips #000 screwdriver to unscrew the three 3.4mm screws. Lift the daughterboard away from the device to remove. Lift the daughterboard away from the device to remove.
  • Use a Phillips #000 screwdriver to unscrew the three 3.4mm screws.

  • Lift the daughterboard away from the device to remove.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Taylor Bratsch

Member since: 09/06/2016

2,167 Reputation

14 Guides authored

Team

iFixit Member of iFixit

Community

128 Members

6,657 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 0

All Time: 51