Introduction

This guide is to show how to replace the battery in a Onda VI10.

  1. Use a number 0 screw driver to remove the four screws.
    • Use a number 0 screw driver to remove the four screws.

    Add Comment

  2. Power Button on the side should be pointing outward.
    • Power Button on the side should be pointing outward.

    • Note: This is so the ribbon cables are not damaged.

    Add Comment

  3. Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    • Heat up the back of the device with a hair dryer to loosen the glue.

    Add Comment

    • Pry up battery from plastic using a nylon spudger or plastic opening tool.

    Add Comment

    • Desolder the two battery cables from the mother board.

    Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Clint Richards

Member since: 03/22/2017

101 Reputation

1 Guide authored

Team

IUPUI, Team S4-G3, Baechle Spring 2017 Member of IUPUI, Team S4-G3, Baechle Spring 2017

IUPUI-BAECHLE-S17S4G3

4 Members

3 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 1

Past 30 Days: 5

All Time: 143