Skip to main content

Fix Your Stuff

Right to Repair

Store

Introduction

The front case of the Omaker M4 provides a protective layer for the speaker cone. Once the front case is removed, the speaker can be accessed.

Parts

No parts specified.

  1. Flip the device over so the front of the device is facing upwards. Make sure to place the speaker on a flat surface
    • Flip the device over so the front of the device is facing upwards. Make sure to place the speaker on a flat surface

  2. Use a T6 Torx Screwdriver to remove the four screws from the front of the device. Use a T6 Torx Screwdriver to remove the four screws from the front of the device.
    • Use a T6 Torx Screwdriver to remove the four screws from the front of the device.

  3. OPEN ALL THE TABS

    RAM Upgrade Kits for Mac

    Shop Kits

    Enough RAM
    For All The Tabs

    Shop Kits
  4. Use a magnet to remove the screws after unscrewing them and place them aside.
    • Use a magnet to remove the screws after unscrewing them and place them aside.

  5. Carefully remove the front case by gently pulling it from the body of the device. Carefully remove the front case by gently pulling it from the body of the device.
    • Carefully remove the front case by gently pulling it from the body of the device.

Conclusion

To reassemble your device, follow these instructions in reverse order.

3 other people completed this guide.

Andrew Entwistle

Member since: 02/17/2016

679 Reputation

4 Guides authored

Team

USF Tampa, Team 2-2, Sullivan Spring 2016 Member of USF Tampa, Team 2-2, Sullivan Spring 2016

USFT-SULLIVAN-S16S2G2

4 Members

6 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 2

All Time: 514