Skip to main content

Introduction

Suctions cups at the bottom of the base can deteriorate over time. This guide will demonstrate how to replace them.

  1. Turn the blender upside down. Remove all screws that connect the bottom panel to the base of the blender (0.5 inch 5 gauge phillip's head).
    • Turn the blender upside down.

    • Remove all screws that connect the bottom panel to the base of the blender (0.5 inch 5 gauge phillip's head).

    • Note: 2 of the screws will be star shaped (in blue).

    • Lift the bottom off of the base.

  2. Pull the damaged suction cup off of its pit. Pull the damaged suction cup off of its pit.
    • Pull the damaged suction cup off of its pit.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Brian Pham

Member since: 09/26/2017

101 Reputation

1 Guide authored

Team

Cal Poly, Team S7-G1, Banghart Fall 2017 Member of Cal Poly, Team S7-G1, Banghart Fall 2017

CPSU-BANGHART-F17S7G1

5 Members

6 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 4

Past 30 Days: 16

All Time: 537