Introduction

Using this guide, the user will be able to replace the small rubber wheel that connects the blade assembly to the blender base.

Image 1/1:
  • Remove the cup from the blender base.

Add Comment

Image 1/2: Image 2/2:
  • Turn the blender over and unscrew the three 14 mm screws holding the slotted base in place.

Add Comment

Image 1/3: Unscrew the four 14 mm screws that are in the deep slots.  This will release the motor from the base. Image 2/3: Unscrew the four 14 mm screws that are in the deep slots.  This will release the motor from the base. Image 3/3: Unscrew the four 14 mm screws that are in the deep slots.  This will release the motor from the base.
  • Using a the standard Phillips head screwdriver bit, remove the slotted black plastic covering and then unscrew the one 11mm screw holding the power cord in place.

  • Unscrew the four 14 mm screws that are in the deep slots. This will release the motor from the base.

Add Comment

Image 1/3: Using a towel, hold the silver fan still.  Twist the small black rubber wheel that is attached to the top of the blender base to the right.  This will remove the wheel for replacement. Image 2/3: Using a towel, hold the silver fan still.  Twist the small black rubber wheel that is attached to the top of the blender base to the right.  This will remove the wheel for replacement. Image 3/3: Using a towel, hold the silver fan still.  Twist the small black rubber wheel that is attached to the top of the blender base to the right.  This will remove the wheel for replacement.
  • CAUTION: the silver blade attached to the motor is very sharp. Use a towel or thick cloth to protect your hands for the next step.

  • Using a towel, hold the silver fan still. Twist the small black rubber wheel that is attached to the top of the blender base to the right. This will remove the wheel for replacement.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

One other person completed this guide.

Morgan Blauth

Member since: 02/24/2016

633 Reputation

5 Guides authored

Team

USF Tampa, Team 1-5, Leahy Spring 2016 Member of USF Tampa, Team 1-5, Leahy Spring 2016

USFT-LEAHY-S16S1G5

2 Members

5 Guides authored

One Comment

This makes zero sense. The pieces in step 4 are separate from those in steps 1-3. You say "hold the silver fan still" but the photo shows someone holding the blades. You also say to twist it to the right. It's nearly always counter clockwise.

blashmarl - Reply

Add Comment

View Statistics:

Past 24 Hours: 2

Past 7 Days: 8

Past 30 Days: 42

All Time: 464