Introduction

Make sure device is unplugged.

  1. Remove slip mat from top of the platter.
    • Remove slip mat from top of the platter.

  2. Remove platter by inserting thumbs in holes and slowly pulling up.
    • Remove platter by inserting thumbs in holes and slowly pulling up.

    • There will be some initial resistance.

  3. Remove damaged belt which will be located below the platter.
    • Remove damaged belt which will be located below the platter.

  4. Free shipping on all orders over $100 or containing a Pro Tech Toolkit!

    Browse Our Store
  5. Install new belt by securing it around the inner ring, located on the back of the platter.
    • Install new belt by securing it around the inner ring, located on the back of the platter.

  6. Place a thumb in each hole.
    • Place a thumb in each hole.

    • You should be able to feel the rubber belt.

    • Gently pull the belt with each thumb, keeping the belt taut around the inner ring.

  7. Secure platter back on turntable while keeping belt taut. Pull belt around motor spindle.
    • Secure platter back on turntable while keeping belt taut.

    • Pull belt around motor spindle.

    • Gently let go of belt.

  8. Test turntable by spinning the platter.
    • Test turntable by spinning the platter.

    • There should be slight tension causing the platter to come to a stop.

Finish Line

One other person completed this guide.

Nikolai

Member since: 10/12/2011

161 Reputation

5 Guides authored

Team

Cal Poly, Team 17-14, Regan Fall 2011 Member of Cal Poly, Team 17-14, Regan Fall 2011

CPSU-REGAN-F11S17G14

4 Members

7 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 2

Past 7 Days: 10

Past 30 Days: 32

All Time: 3,491