Introduction

This guide will show you how to remove and replace the cover of your Nook HD+.

Parts

No parts required.

Wedge the plastic opening tool underneath the frame at the bottom left hand corner of the Nook HD+ and begin prying open the front frame. Note there will be glue and be careful not to brake the clips. Note there will be glue and be careful not to brake the clips.
  • Wedge the plastic opening tool underneath the frame at the bottom left hand corner of the Nook HD+ and begin prying open the front frame.

    • Note there will be glue and be careful not to brake the clips.

Add Comment

Apply glue round the inside perimeter of the new frame on the clip side.
  • Apply glue round the inside perimeter of the new frame on the clip side.

Add Comment

Line up the new frame with the bottom left hand edge of the frame lined up with the hole on the center chaise push down on the frame until all the clips pop back into the slot the belong.
  • Line up the new frame with the bottom left hand edge of the frame lined up with the hole on the center chaise push down on the frame until all the clips pop back into the slot the belong.

    • Run finger around the entire frame making sure all the clips are in place.

    • Let glue dry.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Alex Pelicas

Member since: 10/17/2014

273 Reputation

2 Guides authored

Team

UMass Dartmouth, Team 2-3, Duarte Fall 2014 Member of UMass Dartmouth, Team 2-3, Duarte Fall 2014

UMASSD-DUARTE-F14S2G3

5 Members

5 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 2

Past 30 Days: 4

All Time: 398