Introduction

Installing a new vibration component is necessary when the vibrate mode on your phone is no longer functioning properly. Installation requires no prior knowledge of mobile phone vibrators.

Parts

No parts required.

Image 1/3: Depress the button. Image 2/3: With your other hand, pull the front cover away from the phone. Image 3/3: With your other hand, pull the front cover away from the phone.
  • Locate the small button on the top of the phone.

  • Depress the button.

  • With your other hand, pull the front cover away from the phone.

Add Comment

Image 1/3: Remove the circuit board/faceplate sub-assembly from the back of the phone. Image 2/3: Take care to place screws in a safe location. Image 3/3: Take care to place screws in a safe location.
  • Remove all six 5.3 mm long T6 screws.

  • Remove the circuit board/faceplate sub-assembly from the back of the phone.

  • Take care to place screws in a safe location.

Add Comment

Image 1/3: Remove the vibrator mechanism with tweezers by simply pulling it up and away from the phone. Image 2/3: Remove the vibrator mechanism with tweezers by simply pulling it up and away from the phone. Image 3/3: Remove the vibrator mechanism with tweezers by simply pulling it up and away from the phone.
  • After removing the circuit board/faceplate sub-assembly, locate the vibrator mechanism.

  • Remove the vibrator mechanism with tweezers by simply pulling it up and away from the phone.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

One other person completed this guide.

Parker Niebauer

Member since: 10/22/2012

1 Reputation

6 Guides authored

Team

Clemson, Team 15-3, Benson Fall 2012 Member of Clemson, Team 15-3, Benson Fall 2012

CLEM-BENSON-F12S15G3

3 Members

11 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 1

All Time: 348