Introduction
If you need to replace a Brad Nailer Pressure Regulator Knob, follow the steps outlined in this guide. For this guide, you will need a 2mm Allen wrench. The steps outlined are relatively easy to follow.
What you need
-
-
Using a 2mm Allen wrench, remove the Allen screw located on the pressure regulator knob on the back of the brad nailer.
Ask FixBot
-
-
Conclusion
To reassemble your device, follow these instructions in reverse order.
Team
Washington State, Team S1-G3, Hope Fall 2018 Member of Washington State, Team S1-G3, Hope Fall 2018
WSU-HOPE-F18S1G3
4 Members
3 Guides authored
