Introduction

In this step we will be removing the bottom panel from the rest of the controller. This is necessary in order to access the inside components of the controller.

WARNING: Use caution when removing the bottom grip panel. Many of the buttons and components are held only loosely by the front panel and can fall out. Be sure to set screws aside carefully.

Parts

No parts required.

Image 1/1: Remove the six 9.2mm Tri-wing Y0  screws that hold the back panel in place.
  • Place the controller (buttons down) on a solid surface.

  • Remove the six 9.2mm Tri-wing Y0 screws that hold the back panel in place.

Add Comment

Image 1/1: Some of the buttons may fall out if they are knocked around.
  • Gently lift the back panel up, separating it from the front panel.

  • Some of the buttons may fall out if they are knocked around.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

5 other people completed this guide.

Jeffrey Hufford

Member since: 01/18/2013

65 Reputation

2 Guides authored

Team

Cal Poly, Team 19-44, Regan Winter 2013 Member of Cal Poly, Team 19-44, Regan Winter 2013

CPSU-REGAN-W13S19G44

4 Members

16 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 4

Past 7 Days: 21

Past 30 Days: 63

All Time: 5,192